Yamaha MT-09 Owner's Manual page 65

Periodic Maintenance And Adjustment
1
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 12 lb·ft)
Install the engine oil drain bolt and
8.
7
its new gasket, and then tighten the
bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
43 N·m (4.3 kgf·m, 31 lb·ft)
9. Refill with the specified amount of
the recommended engine oil.
Recommended engine oil:
See page 9-1.
Oil quantity:
Oil change:
2.40 L (2.54 US qt, 2.11 Imp.qt)
With oil filter removal:
2.70 L (2.85 US qt, 2.38 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust
system have cooled down.
NOTICE
In order to prevent clutch
slippage (since the engine oil
also lubricates the clutch), do
not mix any chemical additives.
Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
Make sure that no foreign
material enters the crankcase.
10. Check the O-ring for damage, and
replace it if necessary.
7-14
1
2
1. Engine oil filler cap
2. O-ring
11. Install and tighten the engine oil
filler cap.
12. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the
engine off and check for the
cause.
TIP
After the engine is started, the engine
oil level warning light should go off if
the oil level is sufficient.
NOTICE
If the oil level warning light flickers
or remains on even if the oil level is