Yamaha MT-09 Owner's Manual page 16

Setting the traction control system
1. Traction control system switch "TCS"
With the throttle closed, push this
switch down to change from TCS "1"
to TCS "2". Push up to change from
"2" to"1".
With the vehicle stopped, push this
switch up for two seconds to turn the
system off. Push down to turn the
system on.
TIP
The current TCS setting is shown
in the TCS display (page 4-10).
Traction control can be turned on
or off only when the vehicle is
stopped.
When the key is turned to "ON",
traction control is turned on and
set to "1" or "2" (whichever was last
selected).
Turn the traction control system off
1
to help free the rear wheel if the
vehicle gets stuck in mud, sand, or
other soft surfaces.
TCS "OFF"
TCS "OFF" turns the traction control
system off.
TCS "1"
TCS "1" minimizes traction control
system assist.
TCS "2"
TCS "2" maximizes traction control
assist; wheel spin is most strongly
controlled.
1. Traction control system indicator light
"
2. Engine trouble warning light "
The "
traction control has engaged. You
may notice slight changes in engine
and exhaust sounds when the system
has engaged.
When the traction control system has
been set to "OFF", the "
light will come on.
NOTICE
Use only the specified tires. (See
page 7-19.) Using different sized
tires will prevent the traction
control system from controlling tire
rotation accurately.
3-2
Special Features
1 2
"
"
" indicator light flashes when
" indicator
3