Chapter 4 - Using The Ring Scanner; Overview; Minimum Software Requirements; Updating The Software - Honeywell Dolphin 75e User Manual

4
Using the Ring Scanner

Overview

The 8620 ring scanner is a wearable external image engine that connects to the Dolphin 75e Wearable Solution. It reads
popular 1D and 2D bar codes and supports omni-directional aiming and decoding for greater flexibility in real-world settings.

Minimum Software Requirements

The terminal must have the minimum software requirements to work with the 8620 ring scanner:
• Build number 56.01.12.0160
• Power Tools 3.11.3126
To check the current software version:
1. Touch All Apps
2. Select About phone and check the Build number.
To check the Power Tools version
1. Touch All Apps
2. Select SysInfo and check POWER TOOLS AND DEMOS INFO.

Updating the Software

Software updates are available from
To install a software upgrade:
1. Copy the upgrade file (*.zip) into one of the following folders:
• Internal storage\honeywell\autoinstall on the terminal
Software updates saved to this folder, do not persist when a Factory Reset (Clean Boot) is performed.
• IPSM card\honeywell\autoinstall on the terminal
Software updates saved to this folder, persist when a Factory Reset (Clean Boot) is performed.
• \honeywell\autoinstall on an SD card (if installed)
Software updates saved to this folder, do not persist when a Factory Reset (Clean Boot) is performed.
2. Touch All Apps
3. Select Packages Update from the AutoInstall Settings
installs the software upgrade.
Depending on where you saved the file, you can also initiate a software upgrade using the terminal buttons instead of
the package update option.
If the file is located in the IPSM card\honeywell\autoinstall folder:
• Initiate a terminal Reboot. When the Honeywell logo appears and the green LED turns On, simultaneously press and
hold the Volume Up
If the file is located in the \honeywell\autoinstall on an SD card:
• Initiate a terminal Reboot. When Honeywell logo appears and the green LED turns On, simultaneously press and
hold the Volume Down
> Settings .
> Power Tools > Diagnostic Information
Customer Support
> AutoInstall Settings . Verify Autoinstall is enabled.
and Home buttons until the green LED turns Off.
and Home buttons until the green LED turns Off.
.
or www.honeywellaidc.com.
screen. The terminal automatically initiates a reboot and
4 - 1