Settings Related To The Detection For Overlapped Documents (Multifeed); Specifying A Method To Detect Overlapped Documents [Multifeed] - Fujitsu FI-800R Operator's Manual

Settings Related to the Detection for Overlapped Documents (Multifeed)

Specifying a Method to Detect Overlapped Documents [Multifeed]

Multifeed is an error that occurs when two or more sheets are overlapped and fed at once.
For documents that are loaded in the ADF paper chute (feeder), configure the settings to detect overlapped
documents during a scan.
Overlapped documents are detected with the ultrasonic sensor or according to the difference in length of the
documents.
When overlapped documents are detected, an error message is displayed and the scan stops. If documents are
overlapped within 30 mm from the leading edge, they are not detected as overlapped.
1
Start up the Software Operation Panel.
For details, refer to
2
From the list on the left, select [Device Setting 2] → [Multifeed].
3
Select a detection method.
None
Does not detect overlapped documents.
This is the factory default setting.
Check Overlapping(Ultrasonic)
Detects overlapped documents with the ultrasonic sensor.
Starting Up the Software Operation Panel (page
Scanner Settings (Software Operation Panel)
144).
182