Fujitsu FI-800R Operator's Manual page 161

Setting Item
Multifeed
Page Edge Filler (U-turn)
Page Edge Filler (Return)
Dropout color
Document check area specification for
Multifeed Detection
Intelligent Multifeed Function
Number of paper feeding retries
Cleaning Cycle
Life Counter Alarm Setting
Vertical Streak Detection
Vertical Streak Sensitivity
AutoCrop Boundary
Power SW Control
High Altitude Mode
USB
Description
For documents that are loaded in the ADF paper chute (feeder),
configure the settings to detect overlapped documents during a
scan.
For documents that are loaded in the ADF paper chute (feeder),
configure the settings to fill in the shadow or streaks around the
edges of the scanned image.
For a document that is inserted into the return path opening,
configure the settings to fill in the shadow or streaks around the
edges of the scanned image.
You can exclude a color from being scanned by selecting either
red, green, or blue (three primary colors).
For documents that are loaded in the ADF paper chute (feeder),
specify an area to detect overlapped documents.
For documents that are loaded in the ADF paper chute (feeder),
configure the setting to automatically ignore certain patterns of
overlapped documents when the setting to detect overlapped
documents is enabled.
Specify the number of feeding retries when a document is not
fed from the ADF paper chute (feeder).
Specify the cleaning cycle for the scanner inside.
Specify the replacement cycle for the consumables.
You can configure the settings for detecting dirt on the glass.
Specify the sensitivity level to detect vertical streaks (dirt on the
glass) when [Enable] is selected for [Vertical Streak Detection].
When the scanner is set to detect the paper size automatically,
specify whether or not to optimize (round up/down) the
fractional part of the scanned image.
Specify whether or not to turn on/off the scanner by pressing
the [Power] button on the scanner.
Enable this mode to use the scanner at an altitude of 2,000 m
or higher.
Change the USB setting if a connection between the scanner
and a computer cannot be established.
161
Scanner Settings (Software Operation Panel)