Samsung OfficeServ 7400 Technical Manual page 11

OfficeServ 7400
TECHNICAL MANUAL
PART 2. INSTALLING CABINETS
This section describes how to install an OfficeServ 7400 cabinet on a table/desktop or
in a data rack depending on the installation environment.
2.1 SYSTEM INSTALLATION PROCEDURE
Installation Overview:
1) Install the OfficeServ 7400 cabinet on a table or inside a data rack depending on the
installation environment.
2) Connect the ground to the ground lug behind the main cabinet.
3) Put the MP40 board into slot 3 of the main cabinet. Install an LP40 in slot 0 of the
Main Cabinet. If there are expansion cabinets, install an LP40 board into slot 0 of
each expansion cabinet.
4) Connect the link cables from each LP40 to the MP40. (Do not connect cables to
LP40 in the Main Cabinet).
5) Install interface boards into universal slots.
6) Connect an external battery with proper capacity if required.
7) Connect AC 110 V input power.
2.2 SELECTING INSTALLATION METHOD
The OfficeServ 7400 cabinet can be installed on a table or inside a 19-inch rack.
2.3 INSTALLING IN A RACK
2.3.1 Cautions for Installation
Observe the following precautions when installing the OfficeServ 7400 cabinet inside a
rack:
• The 19-inch rack should be a standard equipment rack.
• When using an enclosed-type rack, check if the rack is properly ventilated. Vents
should be equipped on the side of the rack and fans should be attached to ventilate
cool air into the rack.
•
Take special caution when using an enclosed-type rack that has vents on top of the
rack since hot air coming out of the vent may enter the intake vent of a system
installed above the rack.
• When using an open rack, do not block the OfficeServ 7400 vents or fans.
Home Page
2.1
Table of Contents
INSTALLATION
PART 2 JUNE 2006