Cleaning
Tightening torques
Maintaining the
control stage
HON 5020 gas pressure regulator with HON 630 pilot
Observe the following cleaning instructions:
Before assembly, all parts must be cleaned in order to remove any foreign particles
(swarf) and soiling.
If screws, bolts, or washers are replaced with identical new parts, any oil on these new
parts must first be removed.
Observe the tightening torques below when following the instructions in this section:
Part
Closing cap
Cylinder screws
Hex bolt
Hex bolt
Proceed as follows:
Figure
Tightening torque
20 Nm (15 ft lbs)
6 Nm (5 ft lbs)
12 Nm (9 ft lbs)
12 Nm (9 ft lbs)
Step
Description
1
Release the tension on the pilot spring by
loosening the hex flange nut (1) and
unscrewing the spring adjuster (2) a few
turns.
2
Loosen the screws and lift off the upper
cover.
3
Unscrew the fitting (1) on the upper cover.
Replace the sealing ring (2) with a new,
greased sealing ring.
Lubricate the thread surfaces.
Screw the fitting (1) back in.
Maintenance
Step
21
31
35
37
64