3.3
DIN Installation Steps
3–4
DIN INSTALLATION STEPS CHAPTER 3: MECHANICAL INSTALLATION
1.
Slide meter with NEMA 12 Mounting Gasket into panel. (Remove ANSI Studs, if
in place.)
2.
From back of panel, slide 2 DIN Mounting Brackets into grooves in top and
bottom of meter housing. Snap into place.
3.
Secure meter to panel with lock washer and a #8 screw through each of the 2
mounting brackets. Tighten with a #2 Phillips screwdriver. Do not overtighten.
The maximum installation torque is 0.4 Newton-Meter.
#8 screw
EPM 6000 meter
with NEMA 12
mounting gasket
Remove (unscrew)
ANSI studs for DIN
Installation
FIGURE 3–3: DIN Mounting Procedure
EPM6000 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
DIN mounting
bracket
top-mounting
bracket groove
bottom mounting
bracket groove