Install The Base Station - Cisco 6800 Series Hardware Installation

Handset Package Contents
If you want to mount the repeater on the ceiling, you need to order a separate ceiling mount kit.
Handset Package Contents
Your handset package has the following contents:
• Handset with attached belt clip. Inside the handset is the battery, with a piece of plastic over the battery
• Charging cradle with attached USB cable.
• Regional power adapter for the charging cradle.
• Plastic cover to replace the belt clip on the handset.
• Printed compliance document.
You need the label on the box during handset registration.
Power Requirements
The base station requires one of these power sources:
• Power over Ethernet (PoE) - minimum IEEE 802.3: Power class 2 (3.84 – 6.49W)
• Power adapter specific to your region with a USB-to-power jack cable. The power adapter is plugged
The handset is powered by a 3.7V, 1000mAh, 4.1Wh, Lithium ion battery.
The handset charger power cable plugs into the regional power adapter, and the power adapter must be plugged
into an electrical outlet.

Install the Base Station

When the base station connects to the network, the LEDs light to indicate the network status:
• Green—Connected.
• Amber—Connection in progress.
• Red, flashing—Can't connect to the network.
Hardware Installation
6
contacts.
Note
You need to remove the plastic over the battery contacts. For more information,
see Install the Battery in the Handset, on page
Note Make sure that you save this small plastic cover, in case you want to use the
handset without the belt clip.
into an electrical outlet.
Hardware Installation
16.