Cisco 6800 Series Hardware Installation page 14

Hide thumbs Also See for 6800 Series:

Mount the Base Station or Repeater on the Wall

• With the ceiling mount bracket: Hold the bracket so that two of the holes intersect the line. Mark the

holes.

Step 3

Install the wall plugs as described by the manufacturer.

Step 4

Insert the screws.

• Without the ceiling mount bracket: Screw in the screws until there is about 0.375 inches (9.52 mm)

between the screw head and the wall.

• With the ceiling mount bracket: Hold the bracket over the holes and screw in the screws until the bracket

doesn't move.

Step 5

Base station only: Connect the Ethernet cable to the base station and route the cable through the slot in the

base station.

Step 6

Provide power to the device:

• Base station with PoE on the LAN: Additional power is not required.

• Base station without PoE: Plug the power adapter into the base station and route the cable through the

slot in the base station.

• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.

Step 7

Put the device on the wall.

• Without the ceiling mount bracket: This diagram shows the alignment of the screw heads and the device.

Hardware Installation

Table of Contents