Makita DVC867L Instruction Manual page 17

Description of the wireless activation lamp status
► Fig.33: 1. Wireless activation button 2. Wireless
activation lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the below table for the
meaning of the lamp status.
Status
Color
Standby Blue
Tool Green
registration
Cancelling/ Red
erasing
(slow: 2 times/sec.)
tool
registration
Others Red
Off
Troubleshooting for wireless activation function
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
The wireless activation lamp does
not light/blink.
Wireless activation lamp
Duration
(approximate)
On Blinking
Cleaner: con-
Tool: 2 hours
When the tool is
running.
20 seconds
2 seconds
20 seconds
When the
wireless acti-
(fast: 5 times/sec.)
vation button is
pressed down.
2 seconds
3 seconds
-
Probable cause (malfunction)
The wireless unit is not installed into the
cleaner and/or the tool.
The wireless unit is improperly installed
into the cleaner and/or the tool.
The terminal of the wireless unit and/or
the slot is dirty.
The wireless activation button on the
tool has not been pushed.
The stand-by switch on the cleaner is
not set to "AUTO".
No power supply
Waiting for the tool registration or the wireless activation function
tinuing is available.
The lamp on the cleaner blinks when the stand-by switch is set in
AUTO. The lamp on the tool blinks when the wireless activation
button is pushed. The lamp on the tool will automatically turn off
when no operation is performed for 2 hours.
The wireless activation of the cleaner is available and the tool is
running.
Ready for the tool registration. Searching the tool to be registered.
The tool registration has been finished. The wireless activation
lamp will start blinking in blue.
Ready for the cancellation of the tool registration. Searching the
tool to be cancelled.
Ready to erase all tool registrations.
The tool registration has been cancelled/erased. The wireless
activation lamp will start blinking in blue.
The power is supplied to the wireless unit and the wireless activa-
tion function is starting up.
- The stand-by switch is not set to "AUTO".
17 ENGLISH
Description
Remedy
Install the wireless unit correctly.
Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot of the cleaner and/
or the tool.
Push the wireless activation button on the tool
briefly.
Set the stand-by switch on the cleaner to "AUTO".
Supply the power to the tool and the cleaner.