GE Mark VIe System Manual page 3

Document Updates
Rev Location
IONet Switches
BP
BPPC-based I/O Pack Migration
Intrinsic Variables and Totalizers
Turbine I/O Types
BN
Mark VIeS Safety I/O Types
Signal Reference Structure
BM
Terminal Board Fuse Details
Terminal Board Fuse Details
BL
IONet Switches
Serial Number/Barcode Convention
BK
Terminal Board Fuse Details
Introduction
BJ
Modbus Protocol
BH Introduction
IONet Switches
Approved IONet Switches
Modbus Protocol
BG
Electromagnetic Compatibility Directive (EMC)
2014/30/EU
Low Voltage Directive 2014/35/EU
Humidity
System Guide
Description
Corrected the GE industrial Ethernet 10/100 IONet switch operating
temperature
Removed "although this is not recommended" from table entry on mixing BPPB
and BPPC I/O packs
Updated totalizer support by ControlST version
Added the compatible terminal boards TVBAH1B and TVBAH2B for the
PVIBH1 I/O pack
Added the compatible terminal board TVBAS2B for the YVIBS1 I/O pack
Updated the last paragraph for clarification
Updated IS200TRLYH1C and 2C to include 5 X 20MM TIME-LAG in the table
Power Distribution, Terminal Board Fuses
Corrected IS200JPDDG2A to 3A in the table Power Distribution, Terminal
Board Fuses
Incorporated content from the removed section Approved IONet Switches
section into this section and added Approved IONet Switches as the table
heading for the list of approved IONet switches
New section that provides the logic of the GE serial number/barcode
convention
Added the following terminal boards to the table Power Distribution, Terminal
Board Fuses: IS200JPDDG2A, IS200JPDDG3A, and IS200JPDDG4A; remove
+FU# from GE Part # column
Added Attention statement that users application may not be licensed to
access full system capability and I/O types described in this document
Changes made for clarification, including:
• Removed the note referencing GSM 3.0 documentation, which is not
related to Modbus
• Added a note below the Mark VIe Controller Modbus Communication
Protocols diagrams in the section Controller Modbus to state that the
diagram is not meant to show how to connect Modbus to an application; it
is to give the reader a point of reference as to how Modbus is
implemented.
• Controller was removed from the Mark VIe Controller Modbus
Communication Protocols diagram to limit confusion because it does not
add value; it was only a point of reference
Added content for the Universal I/O (UIO) Mark VIe control cabinet
Corrected the redundant input voltage range from 10–30 to 18–36 v dc
Updated the list of approved IONet ESWx switches
Added Modbus Slave support for Mark VIeS Safety controller
Updated the EU directive number from 2004/108/EC to 2014/30/EU
Added the Code and Description details in the table of fulfilled requirements for
EU directive EN/IEC 61326-1
Updated the EU directive number from 2006/95/EC to 2014/35/EU
Removed EN50178 statement
Public Information
GEH-6721_Vol_I_BP 3