Electrical - GE Mark VIe System Manual

5.3 Electrical

5.3.1 Electromagnetic Compatibility Directive (EMC) 2014/30/EU
Attention
The Mark VIe control fulfils the requirements listed in the following table.
Code
EN 55011:2009 + A1:2010
EN 61000-6-2: 2005
EN/IEC 61326-1
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-4
IEC 61000-4-5
IEC 61000-4-6
IEC 61000-4-11
5.3.2 Low Voltage Directive 2014/35/EU
Under the conditions specified in this document, the Mark VIe control fulfils the requirements of CAN/CSA-C22.2 No.
61010-1-12, UL Std. No. 61010-1 (3rd Edition), and EN 61010-1 (3rd edition) Safety Requirements for Electrical Equipment
for Measurement, Control, and Laboratory Use, Part 1: General Requirements.
Warning
Technical Regulations, Standards, and Environment
Equipment is not approved for use in a residential, commercial or light industrial
environment and should not be connected to a residential electric power network. For
EMC Directive compliance, Mark VIe components shipped loose from the factory
must be installed in an enclosure with a minimum steel thickness of 0.86 mm and have
a minimum Intrusion Protection (IP) of 20.
Description
ISM equipment - Electromagnetic disturbance characteristics
Generic Immunity Industrial Environment
Electrical equipment for measurement, control and laboratory use – EMC requirements
Electrostatic Discharge Susceptibility
Radiated RF Immunity
Electrical Fast Transient Susceptibility
Surge Immunity
Conducted RF Immunity
Voltage Variation, Dips and Interruptions
The protection provided by this equipment may be impaired if it is used in a manner
that is not specified by the manufacturer.
Public Information
GEH-6721_Vol_I_BP System Guide 119