Advertisement
Connecting Multiple Roller Tables
To create a longer work support surface, any com-
bination of the T28172, T28369, and T28370 roller
tables can be connected end-to-end by using the
T28371 Connector Plates.
Items Needed
Additional Person .............................................. 1
Wrench or Socket 18mm ................................... 1
Hex Wrench 6mm .............................................. 1
T28371 Connector Plates .................................. 2
To connect two roller table units end-to-end:
1.
With help from an assistant, place two roller
table assemblies end to end, as shown in
Figure 9.
2.
Adjsut table heights even with each other.
Refer to Installation & Height Adjustment
if necessary.
Figure 9. Placing roller tables end to end to
connect T28371 Connector Plate.
-4-
3.
Working on one side at a time, remove the
(2) flange nuts securing adjoining end roller
shafts (see Figure 10).
Qty
Figure 10. Removing flange nuts on end roller
3.
Install T28371 Connector Plate over thread-
ed end of roller shafts with lips facing out
(see Figure 11). Re-attach flange nuts and
tighten.
Figure 11. Attaching T28371 Connector Plate to
4.
Repeat Steps 2–3 on opposite side of tables
to attach second T28371 connector plate
(see Figure 11).
5.
Check and adjust roller table to assure they
are even with each other across length of the
tables.
T28172/369/370 Roller Tables (Mfd. 10/17)
Remove Flange Nuts
shafts.
End Roller
Shaft
Flange Nuts
end roller shafts.
T28371
Connector
Plate
Advertisement
