Black & Decker LSW20 Instruction Manual page 7

3.Ifthebattery p ack does notcharge p roperly:
a.Check c urrent atreceptacle byplugging ina lamp orother
appliance
b.Check t oseeifreceptacle isconnected toa light s witch
which t urns power offwhen youturn out t helights.
c.Move charger andbattery p ack toa location where t he
surrounding airtemperature isapproximately 60°F and 80°F
(16 °-27°C)
d.Ifcharging problems persist, take thetool, b attery p ack and
charger toyourlocal service c enter.
4.The battery p ack should berecharged when itfails toproduce
sufficient power onjobs which were easily d one previously. DO
NOT CONTINUE touseunder these conditions. Follow thecharging
procedure. Youmay also charge a partially used pack whenever
youdesire w ith noadverse affect o nthebattery p ack.
5.Foreign m aterials ofaconductive nature s uch as,butnotlimited
to,steel wool, aluminum f oil, o ranybuildup o fmetallic particles
should b ekept a way f rom charger cavities. Always u nplug t he
charger from thepower s upply w hen there isnobattery p ack inthe
cavity. Unplug c harger before a ttempting toclean.
6.Donotfreeze o rimmerse charger inwater o ranyother l iquid.
zLWA RNING: Shock hazard. Do n ot allow any
liquid
to get inside charger. Never attempt to open the battery pack for any
reason, ff the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
TO INSTALL BATTERY PACK:
Insert battery pack into tool until an
audible click is heard (figure B). Make sure battery pack is fully
seated and fully latched into position.
TO REMOVE BATTERY PACK:
Depress the battery release button
in the back of the battery pack and
pull battery pack out of tool.