Cisco ONS 15454 Install page 14

Install the shelf and backplane cable

Hide thumbs Also See for ONS 15454:

NTP-A119 Install the Alarm Expansion Panel

Figure 1-3

Step 4

Insert and tighten three screws to secure the AEP to the backplane.

Connect the AEP cable to the backplane and AEP:

Step 5

Connect the 10 colored wires to the wire-wrap pins on the backplane.

cable wires are connected.

Plug the other end of the AEP cable into AEP connector port. The brown pin is on the top.

Cisco ONS 15454 Procedure Guide, R5.0

1-14

Installing Standoffs and the AEP

Wires

AEP cable

Connector

Table 1-1

Chapter 1

shows AEP and AIC-I signals that each wire carries.

Install the Shelf and Backplane Cable

Figure 1-4

shows where the

March 2005