Powerboost1 Information - Honeywell IPGSM-4GC Installation And Setup Manual

IPGSM-4GC Commercial Fire Communicator – Installation and Setup Guide

PowerBoost1 Information

LED Indicator
AC (green)
ACTIVE (green)
LOW BATT (yellow)
TROUBLE (yellow)
Notes:
If AC power is lost and the battery voltage falls below 10v, the PowerBoost1 output voltage will be turned

off. The output power is turned back on when AC power is restored.
You must use the DIP switch settings shown below.

STATUS
AC power available.
Cyclical flashing – normal communications.
Repetition of 3 flashes – loss of communications.
Missing or low battery.
One or more trouble conditions exist, such as; overload, output
supervision, ground fault, or charger failure.
PowerBoost1
LOW BATT LED
INDICATOR
ON
1 2 3 4 5
(Switch handle = white)
iPGSM-COM-003-V0
– 10 –
TROUBLE LED
INDICATOR
Configure DIP switch
as shown:
ON
1 2 3 4 5
AC LED
INDICATOR
ACTIVE LED
INDICATOR