Step 5 - Program The Communicator - Honeywell IPGSM-4GC Installation And Setup Manual

IPGSM-4GC Commercial Fire Communicator – Installation and Setup Guide
STEP 5 – Program the Communicator
You must use the 7720P Programming tool to program the IPGSM-4GC.
When using the 7720P Programming tool, the values given below are for most installations. Press the [#] key to
accept the displayed default value (xxx) or enter the new value and press the [#] key for the next prompt. Use the
[ ] key to scroll through a list of options.
Space
1. (no display)
2.
7720P PROGRAMMER
3.
Strt Prog Mode? Y/N
4.
Program Device? Y/N
5.
Com Path Choice (IP&GSM)
6.
Primary City ID (??)
7.
Primary CS ID (??)
8.
Primary Sub ID (????)
Note: If a Com Path Choice of IP&GSM or IP was selected, prompt 9 will appear.
9.
Use DHCP? Y/N (Y)
Note: If DHCP is not selected (your router is set for a static IP), prompts 10 through 13 will appear. Use
the [Space] key to advance to the next address part.
10.
NIC IP Address:
255.255.255.255
11.
Subnet Mask:
255.255.255.255
12.
Gateway IP Address:
255.255.255.255
13.
DNS Serv IP Addr:
255.255.255.255
14.
Review? Y/N
15.
Create Password? Y/N
16.
Exit Prog Mode? Y/N
17.
DONE
Notes: If an error in programming occurs, set the factory defaults (see next topic) and reprogram.

The IP Fault Time, and the GSM Fault Time are each fixed at 1 minute and are not programmable.

Connect the 7720P. (You can use the [Shift + A] key to check the software
revision.)
Press [#].
Press [Shift] then [Y], then [#].
Press [Shift] then [Y], then [#].
Press [Space] to scroll choices; IP&GSM, IP, or GSM. (When IP, or GSM, or
IP&GSM is chosen, the IPGSM-4GC functions as an active communication
system.) At choice, press [#].
Enter number 01-99, then press [#].
Enter number 01-FE, then press [#].
Enter number 0001-9999, then press [#].
If your router is configured for DHCP, press [Shift] then [Y], then press [#].
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Press [Shift] then [Y], then press [#].
– 7 –