Usage; Care And Cleaning - AEG GYE01016UE User Manual

5. USAGE

5.1 Filling
This sealed unvented
(pressurised) appliance is
intended for heating
domestic hot water. The
appliance can supply one or
more draw-off points.
Once the water heater has been
installed:
1. Open the water source valve.
2. Open the hot tap.
When the water starts to run through it
with constant flow, then the water heater
will be full.
3. Close the hot taps
4. Make sure there are no leaks in the
installation.
5. Check that the safety valve is working
correctly.
WARNING!
Do not connect the water
heater to the main power
supply without being sure
that it is full of water,
otherwise the heating
element may be damaged.
5.2 Adjusting water
temperature
WARNING!
During operation, the tap
and safety valve can reach
temperatures in excess of 60
°C. There is a risk of scalding
at outlet temperatures in
excess of 43 °C.

6. CARE AND CLEANING

WARNING!
All the repair and
maintenance must be
carried out by customer
service authorized
technicians.
You can set any required temperature of
outlet water at the temperature selector,
it's steplessly variable from 11°C (frost
protection) to MAX.
The temperature selector
should only be removed by a
qualified contractor.
Subject to season, varying
cold water temperatures can
result in different maximum
mixed water and outlet
volumes.
5.3 Operating
After the temperature had been adjusted
to the desired value, the heating element
will heat up the water inside the tank
until the water temperature reaches to
the setting value, then heater will go to
OFF state.
After the water inside the tank gets
cooler, and the temperature will be lower
than the setting temperature, the
heating process will start working again
and heat the water inside the tank. The
operation will repeat continuously in
automatic manner as long as the
electrical source connected to the water
heater.
Regularly activate the safety
valve to prevent it from
becoming blocked, e.g. by
limescale deposits.
Appliance malfunctions should be
repaired immediately to keep the
performance of it.