Note: For a quick gauge, fold a dollar bill in half
twice (four thicknesses of a dollar bill is approxi-
mately 0.016") and place it between the support
bearing and the blade as shown in Figure 43
Figure 43.
8.
To adjust the lower support bearings:
1.
2.
3.
Figure 44.
Figure 44
4.
must be re-aligned with the blade after the
lower guide block assembly is adjusted.
Refer to Page 34.
5.
6.
7.
Adjusting Blade
Guide Bearings
To adjust the upper and lower blade guides:
1.
2.
Figure 41
Note: The table
Figure 42
Figure 43