Grizzly EXTREME Series Owner's Manual page 29

Dust Collection
DO NOT operate the Model G0514X/G0514X/
G0514X3 without an adequate dust collection
system. This saw creates substantial amounts
of wood dust while operating. Failure to use
a dust collection system can result in short
and long-term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection hose:
1.
Figure 31
2.
Note: A tight fit is necessary for proper
performance.
Figure 31.
Installing Fence
To install the fence:
1.
Figure 32
2.
Figure 32
Figure 32.
3.
Figure 33
Figure 33.