Add Trust Domain; Trust Domain For Ip Passthrough - ZyXEL Communications LTE Series User Manual

The following table describes the fields in this screen.
Table 106 Maintenance > Remote Management > Trust Domain
LABEL
Add Trust
Domain
IP Address
Delete

27.5 Add Trust Domain

Use this screen to add a public IP addresses or a complete domain name of a device which is allowed
to access the Zyxel Device. Click the Add Trust Domain button in the Maintenance > Remote
Management > Trust Domain screen to open the following screen.
Figure 182 Maintenance > Remote Management > Trust Domain > Add Trust Domain
The following table describes the fields in this screen.
Table 107 Maintenance > Remote Management > Trust Domain > Add Trust Domain
LABEL
IP Address
OK
Cancel

27.6 Trust Domain for IP Passthrough

Use this screen to view a list of public IP addresses/complete domain names which are allowed to
access the Zyxel Device in IP Passthrough mode (bridge mode). IP Passthrough allows Internet traffic to
go to a LAN computer behind the Zyxel Device without going through NAT. Make sure to enable IP
Passthrough in Network Setting > Broadband > Cellular IP Passthrough. See
details.
Click Maintenance > Remote Management > Trust Domain for IP Passthrough to open the following
screen.
Chapter 27 Remote Management
DESCRIPTION
Click this to add a trusted host IP address.
This field shows a trusted host IP address.
Click the Delete icon to remove the trusted host IP address.
DESCRIPTION
Enter a public IPv4/IPv6 IP address which is allowed to access the service on the Zyxel Device
from the WAN.
Click OK to save your changes back to the Zyxel Device.
Click Cancel to restore your previously saved settings.
LTE Series User's Guide
251
Section 6.9 on page 97 for