NETGEAR FlexPower ONVIF VNC4030-111PAS Quick Start

Quick Start
FlexPower ONVIF Wire-Free IP Camera
Model VNC4030-111PAS
© NETGEAR, Inc., NETGEAR and the NETGEAR Logo are trademarks of NETGEAR, Inc. Any non-NETGEAR
trademarks are used for reference purposes only.
NETGEAR INTL LTD
Building 3, University Technology Centre
Curraheen Road, Cork, Ireland
September 2017
Package Contents
FlexPower Rechargeable
Camera battery
Outdoor mount
Mounting screws
(2 sets of 2)
Camera LED Guide
Camera State LED Behavior
General Blinks blue once. The camera was powered on.
Blinking blue and amber. A firmware update is in progress. Do not turn
off the camera.
Off. The camera is either powered off or is powered on and is synced to a
base station.
Syncing Slow blinking blue. The camera is attempting to sync to a base station.
Fast blinking blue. The camera is syncing with a base station.
Fast blinking amber. The camera did not sync.
Charging Fast blinking blue. The camera is connected to power and is charging.
Solid blue. The camera is powered on and the battery is fully charged.
Slow blinking amber. The camera battery charge is low.
Fast blinking amber. The power connection failed.
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134, USA
Power adapter
Power cable
Outdoor Magnetic wall
mount plate mount
Drywall anchors
Step 1: Insert the Battery
1. Unlock the battery compartment by pressing and holding the latch.
2. Gently pull the battery door back to open the compartment.
3. Align the battery contacts.
4. Insert the battery.
5. Close the battery door.
Step 2: Sync Your Camera With the Base Station
You must install the base station before you can sync the cameras.
1. Bring the camera within 2 to 4 feet (60 to 120 cm) of the base station.
2. Press the Sync button on the front of the base
station for about two seconds and release the
button.
The base station camera LED blinks green.
3. Press the Sync button on top of the camera for
about two seconds and release the button.
The camera LED blinks blue. When the camera is synced to the base station, the
camera LED blinks rapidly to confirm sync.
Note: The camera LED blinks amber if the sync is not successful. You must repeat
the sync process.