Transmitter Pv Display; Table 7-2: Transmitter Pv Display - Honeywell SmartLine STIW400 User Manual

7.2

Transmitter PV display

In PV display, the following information is displayed in sequence.
Item displayed
PV value
PV engineering units
PV status
Device status
Sensor Status
Sensor Channel Status
Radio Status
Radio Status
PV Channel
PV Unit
PV Unit
PV Unit
PV Unit
PV Unit
Diagnostic information
Diagnostic information
Diagnostic information
Diagnostic information
Calibration Information
Calibration Information
PV Limit
PV Limit
Revision 1

Table 7-2: Transmitter PV display

Example
4.7
OHMS
BAD
LOW BAT
OOS
NoChEn
RSSI
RSQI
CHAN #
DEG C
DEG F
PERCENT
mV
mA
OVR TEMP
OVR LOAD
SNSR ERR
INPT BAD
CAL ERR
FACT ERR
LIMIT LO
LIMIT HI
SmartLine Wireless Temperature and Universal I/O User's Manual
7.2. Transmitter PV display
Details
Latest PV value.
See Table 7-5.
See Table 7-5. If PV status is not displayed,
then the PV value is good.
See Table 7-5. If multiple device status
messages are in effect, they are displayed one
message per channel until all messages have
been displayed.
If no device status is displayed, then the device
status is normal.
Out of Service
No channel enabled
RSSI signal value returned from GXRM radio,
values as per table...
RSQI signal value returned from GXRM radio,
values as per table...
Channel number, followed by PV
PV temperature units in Celsius
PV temperature units in Fahrenheit
% of range setting
Milli Volt, voltage measurement
Milly Amps, current measurement
Over Temperature diagnostic detail
Over Load diagnostic detail
Sensor diagnostic status reported on LCD
Input Status diagnostic status reported on LCD
Calibration Error
Factroy Error
PV Status below limit low
PV Status below limit High
7. Operation
45