Rotate Display; Tools Required; Procedure; Display Adjustment - Honeywell SmartLine STIW400 User Manual

3.8

Rotate display

If the transmitter's mounting is such that the display is not horizontal, you can rotate the display
90 degree clockwise or counterclockwise to provide horizontal viewing.

Tools required

•
#1 Phillips Screwdriver or 1/8" Slotted Screwdriver
•
Torque Screwdriver
• 1.5 mm hex key

Procedure

WARNING
Risk of death or serious injury by explosion. Do not open transmitter
enclosure when an explosive gas atmosphere is present.

Display adjustment

Step
1
Honeywell recommends that the transmitter be removed from service and moved to a
clean area before servicing.
2
Loosen the M3 locking set screw on the display end-cap. See item 1 in
Unscrew and remove the end cap.
3
Loosen the two captive screws on the display/electronics module. See items 2 in
Figure 3-7
4
Rotate the display 90 degrees in either direction so the screws line up with the
threaded holes. Do not rotate more than 90 degrees or you could damage the wires
behind the display.
5
There are two connectors on the back of the display/electronics module, J4 and J5,
either of which can be used to connect to the meter body cable. If required, move the
meter body cable to the other position.
6
Re-attach the display's two captive screws. Tighten to 0,4 – 0,6 Nm (3.5 – 5.3 lb-in.).
7
Replace end cap and tighten M3 locking screw.
Revision 1
CAUTION
Take precautions against electrostatic discharge to prevent damaging the
display/electronics module.
.
SmartLine Wireless Temperature and Universal I/O User's Manual
Action
3. Installation
3.8. Rotate display
.
Figure 3-7
19