15 . 1.1.3 Load safety information NOTICE! The Z5458 AL Base plate is designed to stack a total of 3 x AL60/ AL90 or ALi60/ALi90 cabinets either directly on the ground or on top of applicable subwoofer. 1.2 Scope of supply Please verify the shipment for completeness and proper condition of the items.
4. Release the button to lock the pin ( [l]). 5. Recheck the Locking pin is securely locked by briefly pulling the Locking pin towards you. d&b Z5458 AL Base plate Rigging manual 1.1 en...
3. Refit and lock Refit the ring cotter by pushing the straight wire shaft through the hole and pressing the front wire loop underneath the straight wire shaft. d&b Z5458 AL Base plate Rigging manual 1.1 en...
2. To park the Splay link, proceed in reverse order and ensure the extension tube is fully pushed in and the head is aligned correspondingly, as shown in the graphic opposite. d&b Z5458 AL Base plate Rigging manual 1.1 en...
1. Fold out the Splay link as previously described. 2. Pull out the extension tube to its stop position. 3. Turn the extension tube head counter clockwise by 90° to fix the extended length of the Splay link. d&b Z5458 AL Base plate Rigging manual 1.1 en...
1. Release the Locking pin. 2. Move the Splay link to the desired hole position in the rigging slot. 3. Insert the Locking pin and ensure the pin is fully inserted and properly locked. d&b Z5458 AL Base plate Rigging manual 1.1 en...
3.2.1 AL ground stack 1. Prepare the Base plate 1. Fix the Splay link of the Base plate in the required hole position. 2. Position the Base plate on the ground. d&b Z5458 AL Base plate Rigging manual 1.1 en...
Page 11
(35° hole) or downtilt (20° hole). Aiming of the first cabinet Shown: –10° down tilt 3. Insert the Locking pin of the cabinet and ensure the pin is fully inserted and properly locked. d&b Z5458 AL Base plate Rigging manual 1.1 en...
Page 12
2. Insert the respective Locking pin and ensure the pin is fully inserted and properly locked. To add a third cabinet, proceed in the same manner until the assembly is completed. d&b Z5458 AL Base plate Rigging manual 1.1 en...
Page 13
▪ Check all Front links on both sides of the cabinets. ▪ Check the splay angle settings and the Splay links at the rear of the cabinets and ensure all Locking pins are properly inserted and locked. d&b Z5458 AL Base plate Rigging manual 1.1 en...
4. Refit the fixing bolt [4]. 5. Refit and lock the ring cotter [5]. 6. Fold the Splay link back into its park position [Þ ] and reinsert the Locking pin. d&b Z5458 AL Base plate Rigging manual 1.1 en...
® ▪ Regularly lubricate the Locking pins using WD-40 or a similar product. Z5458 AL Base plate Visual inspection regarding deformation and damage (e.g. cracks and corrosion) including all drilled holes of the component. d&b Z5458 AL Base plate Rigging manual 1.1 en...
Declarations Declarations 5.1 Manufacturer's declaration This declaration covers: ▪ d&b Z5458 AL Base plate. National standards and technical specifications applied: DIN 18 800, DIN 1055, DGUV Vorschrift 17. Backnang, 2019-08-12 Frank Bothe, Chief Technology Officer (CTO) d&b audiotechnik GmbH & Co. KG 5.2 Disposal...