Table of Contents
Advertisement
BATTERY REMOVAL / INSTALLATION
1.
Battery removal
Hold the handle tightly and push the battery latches
to remove the battery (see Fig. 3, 4).
CAUTION
Never short-circuit the battery.
2.
Battery installation
Insert the battery while observing its polarities
(see Fig. 4).
CHARGING
Before using the power tool, charge the battery as follows.
1.
Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle, the
pilot lamp will blink in red (At 1- second intervals).
2.
Insert the battery into the charger.
Firmly insert the battery into the charger as shown in Fig. 5.
3.
Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in red.
When the battery becomes fully recharged, the pilot lamp will
blink in red. (At 1-second intervals) (See Table 2)
Ventilation holes
Latch
Battery
29
English
Terminals
Battery cover
Fig. 3
Battery
Handle
Latch
Push
Insert
Pull out
Fig. 4
Pilot lamp
Charger
Fig. 5
Battery
Advertisement
Chapters
Table of Contents
