Specifications; Standard Accessories; Battery Removal/Installation - Hitachi WH 10DFL Handling Instructions Manual

5. Do not connect directly to an electrical outlets or
car cigarette lighter sockets.
6. Do not use the battery for a purpose other than
those specified.
7. If the battery charging fails to complete even when
a specified recharging time has elapsed,
immediately stop further recharging.
8. Do not put or subject the battery to high
temperatures or high pressure such as into a
microwave oven, dryer, or high pressure container.
9. Keep away from fire immediately when leakage or
foul odor are detected.
10. Do not use in a location where strong static
electricity generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears
abnormal during use, recharging or storage,
immediately remove it from the equipment or
battery charger, and stop use.
CAUTION
1. If liquid leaking from the battery gets into your
eyes, do not rub your eyes and wash them well
with fresh clean water such as tap water and contact
a doctor immediately.
If left untreated, the liquid may cause eye-problems.

SPECIFICATIONS

POWER TOOL
No-load speed
Capacity (Ordinary bolt)
Tightening torque (Maximum)
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

1 Plus driver bit (No. 2 × 50L) ............. 1
2 Battery (BCL1015) ............................. 2
WH10DFL
3 Charger (UC10SFL) ........................... 1
(2LCSK)
4 Plastic case ........................................ 1
5 Battery cover ..................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (BCL1015)
Optional accessories are subject to change without notice.
UC10SFL
10.8 V
0.35 kg
2. If liquid leaks onto your skin or clothes, wash well
with clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using
the battery for the first time, do not use and return it
to your supplier or vendor.
WARNING
If an electrically conductive foreign object enters the
terminals of the lithium ion battery, a short-circuit may
occur resulting in the risk of fire. Please observe the
following matters when storing the battery.
Do not place electrically conductive cuttings, nails,
steel wire, copper wire or other wire in the storage
case.
Either install the battery in the power tool or store
by securely pressing into the battery cover until
the ventilation holes are concealed to prevent short-
circuits (See Fig. 1).
0-2500 min
M5 – M12
95 N·m
BCL1015: Li-ion 10.8 V (1.5 Ah 3 cells)
1.0 kg
APPLICATIONS
Driving and removing of machine screws, wood
screws, tapping screws, etc.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a
receptacle, the pilot lamp will blink in red
(At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it contacts
the bottom of the charger as shown in
Fig. 3.
English
–1
6