Table of Contents
Advertisement
English
CAUTION
If the guide sleeve does not return to its original position, then the bit is not
installed properly.
HOW TO USE
1.
Check the rotational direction
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the pushing
button.
The L-side of the pushing button is pushed to
turn the bit counterclockwise (See Fig. 7) (The
and
marks are provided on the body).
CAUTION
The pushing button cannot be switched while the impact driver is turning. To
switch the pushing button, stop the impact driver, then set the pushing button.
2.
Switch operation
○
When the trigger switch is depressed, the tool rotates. When the trigger is released, the tool
stops.
○
The rotational speed can be controlled by varying the amount that the trigger switch is
pulled. Speed is low when the trigger switch is pulled slightly and increases as the trigger
switch is pulled more.
○
When releasing the trigger of the switch, the brake will be applied for immediate stopping.
NOTE
A buzzing noise is produced when the motor is about to rotate. This is only a noise, not a
machine failure.
3.
Using the hook
The hook is used to hang up the power tool to your waist belt while working.
CAUTION
○
When using the hook, hang up the power tool fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an accident.
○
When carrying the power tool with hooked to your waist belt, do not fi t any bit to
the tip of power tool. If the sharp bit such as drill is fi tted to the power tool when
carrying it with hooked to your waist belt, you will be injured.
○
Install securely the hook. Unless the hook is securely installed, it may cause an
injury while using.
Trigger switch
mark
32
mark
Pushing button
Fig. 7
Advertisement
Chapters
Table of Contents
