Makita 9561CR Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Armature, Spiral Bevel Gear 11 on Armature shaft (cont.)
ASSEMBLING
(1) Assemble Armature to Gear housing cover. Refer to Fig. 5.
(2) Assemble Lock spring 12 and Spiral bevel gear (small). Refer to Fig. 4.
< Note> Lock spring 12 has to be replaced with the fresh one, when Spiral bevel gear (small) is replaced.
(3) Assemble M6 hex nut or Retaining ring. Refer to Fig. 3.
(4) Assemble the commutator end of Armature as illustrated in Fig. 7R.
Fig. 7F
Wrong
Wave washer 6 can
not press Magnet
sleeve toward Self
lock 6 to stabilize
Magnet sleeve.
(5) Assemble Gear housing cover with Armature and Gear housing complete to Motor housing as illustrated in Fig. 8.
Fig. 8
Gear housing cover
Gear housing complete
Spindle
[3]-2 Spiral Bevel Gear 38 on Spindle and Ball Bearing 6201DDW
DISASSEMBLING
When disassembling the above mentioned parts from Bearing box, it is not necessary to disassemble Gear housing
complete from Motor housing.
(1) Remove bearing box from Gear housing complete as illustrated in Fig. 9.
Fig. 9
Remove M4x16 hex socket head bolt.
M4x16 Hex socket
head bolt (4pcs.)
Fig. 7R
Return tabs of Self lock 6 to their
normal shape before assembling.
Self lock 6
Magnet sleve
Wave washer 6
Right hand thumb
Switch knob
Strike the illustrated position with Plastic hammer
if it is difficult to remove the Bearing box by hand.
Bearing box
Correct
Press down Self lock 6 until
Wave washer 6geats flat.
Spindle has to be located on bottom side when Switch
knob is controled by the right hand thumb.
P 4/ 9
Magnet sleeve is
stabilized between
Self lock 6 and
Wave washer 6
by the reaction of
Wave washer 6.