Makita 9561CR Technical Information page 3

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Armature, Spiral Bevel Gear 11 on Armature shaft (cont.)
DISASSEMBLING
(2) Remove Motor housing and Gear housing complete by loosening 4x18 Tapping screws (4pcs.). And then remove
M6 Hex nut from Armature as illustrated in Fig. 3.
Fig. 3
Gear housing
complete
4x18 Tapping
screw (4pcs.)
(3) Armature's Drive end can be disassembled as illustrated in Figs. 4, 5.
Fig. 4
Remove Flat washer 6.
Fig. 5
Remove Retaining ring S-12. And remove Armature from Gear housing cover with arbor press.
Now the disassembly of Armature's drive end is finished.
1R291
Retaining
ring S-12
(4) Armature's Commutator end can be disassembled as illustrated in Fig. 6.
Fig. 6
Remove three tabs of Self lock 6 from
Armature shaft with tweezers, and
separate Self lock 6 from Armature.
Self lock 6
Tweezers
Remove Magnet sleeve, Wave washer 6
and Labyrinth rubber ring 22 .
M6 Hex nut
Gear housing
cover
Armature Motor housing
Hooking Spiral bevel gear 11 with the jaws of 1R269, remove the gear together
with Lock spring 12.
Spiral bevel 1R269
gear 11
Lock spring 12
Armature
Armature
Magnet
sleeve
Wave
washer 6
Labyrinth
rubber
ring 22
Wrench 10
Lock spring 12
Retaining
ring S-12
1R269
Ball
bearing
627DDW
Remove Ball bearing
627DDW with 1R269.
P 3/ 9
Spiral bevel gear 11
Flat
washer 7
Insulation
washer
Remove Flat washer 7
and Insulation washer.