Table of Contents
Advertisement
9
Tighten and install the components of the
waterproof connector.
Pass the I/O combo cable (if applied) through the
routing hole, and attach a rubber seal ring. Install
the combo cable with the white headers inside the
camera, and tighten the stainless hex nut from the
inside of the camera.
Connect the white headers of the I/O combo cable
to the J9 and J14 headers on the camera PCB board.
10
Connect the I/O combo cable on the outside of
the cameras.
Note
Protect against moisture by using putties.
11
Connect a ground wire.
Prepare a cable with a resistance lower than
4Ω and a diameter larger than 20AWG.
Connect the ground wire to the camera with an
M4 screw.
7
Advertisement
Table of Contents
