Preparations
Check the serial number
Write down the serial number and MAC address on
the camera label for later reference.
Connect cable
To connect a cable in order to suit your
requirements, perform the following steps.
1
Remove the dome cover.
Open the dome cover by loosening 4 T10 anti-
tamper screws.
2
Remove the waterproof connectors.
If you do not need to route I/O wires, leave the
plastic cap in place. If you need to connect I/O
wires, keep the stainless nut.
Use an Ethernet cable with a cable diameter
between ø5 mm (13/64 inches) to ø6.3 mm
(1/4 inches).
3
Make holes in the ceiling.
Attach the Alignment Sticker to a position you
prefer.
Drill screw holes where "Drill hole" and "cable
hole" are indicated.
5
5 to 6.3 mm