Checklist; Type Overview - AEG THYRO-S Series Operating Instructions Manual

8.4 Checklist

• LED ON greenn lights up -> mains voltage available
• LED ON green does not light up
Check fuse control 500V 1.6 A, if defective, check external wiring, also applies
to faults of external fusing, check Power Controller fusing. If fuse is defect then
check load and wiring to load. Synchronization voltage is supplied to X1.1.
Check 5 Volt to X22.2. If this voltage is absent or too low, there is a defective
component.
• Supply available but no load current
Check connection signal (digital set point) is present
Check for interruption in load circuit
Check blinking LED signals (chapt. 3.2)
• Load current does not have expected value
Check connection signal (digital set point) for continuous signal ON
With optional bus module
Check bus connection signal (bus set point) for continuous signal ON
Check all parallel load resistances for current conduction
• Load current flows uncontrolled
Check connections in the controller (with initial commissioning)
In rare cases a Thyristor short-circuit can occur

9. Type overview

➜
Thyristor switches with integrated semiconductor and system bus interface.
Type capacity [kW]
Current 230V 400V 500V
Type
1S
H 1 8 1.8 3.2
H 1 16 3.7 6.4
H 1 30 6.9 12
H 1 45 10 18
H 1 60 14 24
H 1 100 23 40
H 1 130 30 52
H 1 170 39 68
HF 1 280 64 112
50
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Dimens. in mm / kg
W H D Weight Dim.
Dissi-
pation
[W]
40 121 127 0.6
8 30 45 121 127 0.7
15 47 45 121 127 0.7
22.5 48 52 190 182 1.7
30 80 52 190 182 1.7
50 105 75 190 190 1.9
65 150 125 320 237
85 210 125 320 237
140 330 125 370 237
Current Fuse
draw. transf. F1
850 12
851 40 20
851 40 40
853 100 63
853 100 100
854 100 180
4 856 150 200
4 856 200 315
5 858 300 350