Makita DFL651F Instruction Manual page 7

Function
Warning for battery This indicates the appro-
cartridge capacity priate time to replace
the battery cartridge
when the battery power
becomes low.
Checking the remain- This function works
ing battery capacity, when the battery power
Autostop is almost used up. At
this time, tool stops
immediately.
Check the LED indi- This function works to
cator, light and beeper check the proper opera-
operation tion of the LED indicator,
light and beeper when
a battery cartridge has
been inserted into the
tool.
Anti-reset of controller This function works
when an abnormal drop
of the battery voltage
occurs for some reason,
and the tool stops.
Overheat This function works
when the temperature
of the controller goes up
very highly, and the tool
stops.
Operation error of the This function works to
switch trigger avoid the tool's immedi-
ate start upon insertion
of battery cartridge into
the tool with the switch
trigger being pulled.
Motor failure Motor failure has been
detected. At this time,
tool does not work.
Double-hitting detection This function works
when a screw is refas-
tened after fastening.
Maintenance alarm This function shows the
maintenance time has
come according to your
preset number of screws
driven.
Tool in connection with This function shows data
PC (no data communica- cannot be exchanged
tion started/communica- between the tool and
tion unavailable) PC in spite of the
connection.
Tool in connection with This function shows
PC (data communication the tool is connected to
started) PC and data exchange
between the tool and PC
can be done in normal
conditions.
Status Status of the LED indicator/beeper
LED indicator
Flickers in red slowly.
Lights up in red.
Lights up first in green,
next red.
(And then the light
comes on.)
Flickers in red and green
alternatively.
Flickers in red quickly.
Flickers in red and green
alternatively.
Flickers in red and green
alternatively.
Lights up in red.
Flickers in yellow.
Flickers in yellow.
Flickers in green.
Beeper
A series of long beeps
A long beep
A series of very short
beeps
A series of short beeps
A series of short beeps
A series of short beeps
A series of short beeps
A long beep
7 ENGLISH
Action to be taken
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
–
Replace the battery with
fully charged one.
Remove the battery car-
tridge immediately and
cool the tool down.
Release the switch
trigger.
Ask your local Makita
Service Center for repair.
–
– Reset the alarm with the
application software.
– Restart the application
software and re-connect
the USB cable.
– –