Makita DFL651F Instruction Manual page 6

A
► 1. Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
Lighting up the lamp(s)
CAUTION:
• Do not look in the light or see the source of light
directly.
LED indicator / Beeper
► 1. LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function
Auto-stop fastening
Warning against insuffi-
cient fastening
1
B
1
Status
This function works Lights up in green for
when the tool has approximately one
reached the preset second.
fastening torque and
normal tightening has
been completed. This
helps overtightening to
be avoided.
Insufficient fastening has Lights up in red.
been performed when
the switch trigger has
released before reaching
the preset fastening
torque.
► 1. Lamp
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp automatically goes out 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Status of the LED indicator/beeper
LED indicator
A long beep
6 ENGLISH
1
Action to be taken
Beeper
–
Retighten the screw.
–