Wiring Burglary, Panic And Smoke Detector Devices To Zones 1-9; Figure 3-8: Telephone Line Connections; Figure 3-9: Wiring Connections For Zones 1-9 - Honeywell VISTA-128BPEN Installation And Setup Manual

Reporting Formats
The system supports the following formats:
ADEMCO Low Speed 3+1; 4+1; 4+2; Sescoa/Radionics 3+1; 4+1; 4+2; ADEMCO 4+2 Express; ADEMCO High Speed;
ADEMCO Contact ID
TERMINALS
ON CONTROL

Wiring Burglary, Panic and Smoke Detector Devices to Zones 1-9

The maximum zone resistance is 100 ohms for zones 1 and 8, and 300 ohms for all other zones (excluding the
2K EOL resistor).
To wire burglary and panic devices to zones 1-9, connect sensors/contacts to the hardwire zone terminals (10 through
23). See Figure 3-9. Connect N.C. and N.O. devices as follows:
•
Connect N.C. devices in series with the high (+) side of the loop. The 2K EOL resistor must be connected in series
with the devices, following the last device.
•
Connect N.O. devices in parallel (across) the loop. The 2K EOL resistor must be connected across the loop wires
at the last device.
Figure 3-9: Wiring Connections for Zones 1-9 Using 2-Wire Smoke Detectors on Zone 1
Zone 1 can support up to 16 2-wire smoke detectors.
Incoming
Handset Telco Line
26 27 28 29

Figure 3-8: Telephone Line Connections

Red Jumper
ZONE 2 ZONE 3 ZONE 4 ZONE 5
10 11 12 13 14 15 16
ZONE 1
+ +
-
N.C.
N.C.
N.O. N.O.
2k EOLR 2k EOLR
+
+ -
Fire
Usage
N.C.
SMOKE
N.O.
N.C.
Burg.
Usage
2k EOLR
N.O.
Zone resistance (Excluding EOLR):
ZONE 1,8: 100 OHMS MAXIMUM
2k EOLR
ALL OTHER ZONES: 300 OHMS MAXIMUM
30
EARTH GROUND
INCOMING TELCO LINE
DIRECT
CONNECT
CORD TIP
RJ31X
RING
JACK
PLUG
ZONE 6 ZONE 7 ZONE 8 ZONE 9
17 18 19 20 21 22
+ +
-
N.C.
N.C.
N.O. N.O.
2k EOLR 2k EOLR
+
+
-
GLASS
BREAK
N.C.
N.C.
N.O.
N.O.
2k EOLR
2k EOLR
Zone response time:
ZONES 1-9: 350mSec-500mSec
Installing the Control
PREMISES
PHONES
23
- +
N.C.
N.C.
3-7