Installing Add On Module (Adm); Connecting The Interface Unit - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
3.10
___________________________________________________________________________________
System Hardware Manual
Password
Locks access to these settings and those at the user level.
When making changes, the application must be closed and
started again to become effective.

Installing Add on Module (ADM)

The D16(LD)-R ADM creates a 16 button Phonebook directory. The interface
for this unit shown in Figure 9-62 ADM Interface Unit
adapter connector for the applicable multiline terminal. When another adapter
needs to be added, this interface must be moved to the left adapter connector
to preserve the cable integrity.
DSW1
Position
3.10.1

Connecting the Interface Unit

1. Set DSW1 to the pattern for the applicable multiline terminal as
shown in
2. Place the ADM and multiline terminal upside down and remove
the Base Units.
O N
3
1
1 2 3 4 5 6 7 8
Figure 9-62 ADM Interface Unit
Table 9-12 DSW1 Switch Positions
Document Revision 3
is connected in the right
DSW1
ON
1 2 3 4 5 6 7 8
on the next page.
9 - 61