Installing The M1756A Fax Modem - HP PageWriter XL M1705B Service Manual

Installing the
To install the cardiograph on the cart:
Cardiograph and
Modems on the Cart
1. Set the cardiograph on the top rails so that the cardiograph's
rear feet drop into the notches on the horizontal rail edges. The
operator panel must face the cart handle.
2. Slide the cardiograph away from the handle, making sure that the
slots on the feet engage the rail edges.
3. Lock the cardiograph in place by installing the locking screw.
The locking screw passes through the hole in the left cart rail
and screws into the threaded hole on the left underside of the
cardiograph.
Attach the Hayes@ modem to the cart as shown in Figure 2-l:
Figure 2-1. Installing the Hayes@ Modem.
Installing the M1756A Fax Modem
Note .I
t?
ECG fax capability is also available using the M170GB modem with
A.03.X3 or higher software.
To install the fax modem, perform the following steps (see
Figure 2-2):
1. Press the (On-Standby) switch to turn the cardiograph to Standby.
2. Turn the cardiograph AC switch off.
3. Insert the larger connector end of the fax/modem cable
(M1752-61600) into the RS-232C plug on the fax/modem, as
shown
in Figure 2-2.
4. Place the fax/modem flat into the bracket so that its data cable
is retained by the two upright tabs at the narrow end of the
bracket. The battery compartment should be accessible through
the cutout at the wide
end
of the bracket.
2-2 Installation and Configuration