Replacing The Battery; Fitting The Battery Holder Tab Into The Battery Slot - HP PageWriter XL M1705B Service Manual

Replacing the Battery
To replace the battery:
1. Install the battery in the battery holder. Make sure the tab on the
holder fits into the slot on the battery as shown in Figure 7-2.
Figure 7-2. Fitting the Battery Holder Tab Into the Battery Slot.
A. Battery slot
2. Gently slide the battery aud holder into the battery compartment
until completely seated.
3. Finger-tighten the thumbscrews on the battery holder.
4. Press the (On-Standby) switch to turn the cardiograph On.
5. Check that the AC indicator and one or more battery level
indicators are lit.
Note .I
$
To insure full battery capacity, charge the battery for 24 hours after
you install it in the cardiograph. The battery will charge as long as
the cardiograph is connected to AC and the AC switch is on.
Note ,I
w
To verify battery capacity, turn on the unit while the cardiograph is
connected to AC power and the AC switch is on. It is important that
the cardiograph is connected to AC power when verifying battery
capacity.
7-4 Removal and Replacement