Cisco vEdge Series Hardware Installation Manual page 180

Ports and Connectors
Table 59:
P i n Signal
1 VeeT
2 TX_Fault
3 TX_Disable
4 SDA
5 SCL
6 MOD_ABS
7 RS0
8 RX_LOS
9 RS1
1 0 VeeR
1 1 VeeR
1 2 RD-
1 3 RD+
1 4 VeeR
1 5 VccR
1 6 VccT
1 7 VeeT
1 8 TD+
1 9 TD-
2 0 VeeT
Network Port LEDs
Each network port on the vEdge 2000 router has two LEDs—the link/activity/status LED and the LAN/WAN
LED. See Figures 1 through 3.
Figure 1: LEDs on the Built-in SFP Network Ports on a vEdge 2000 Router
Hardware Installation Guide for vEdge Routers
174
Description
Module transmitter ground
Module transmitter fault
Transmitter disable
Two-wire serial interface data line
Two-wire serial interface clock
Module absent
Rate select 0; optionally controls SFP+ module receiver
Receiver loss of signal indication
Rate select 1; optionally controls SFP+ transmitter
Module receiver ground
Module receiver ground
Receiver inverted data output
Receiver non-inverted data output
Module receiver ground
Module receiver 3.3-V supply
Module transmitter 3.3-V supply
Module transmitter ground
Transmitter non inverted data input
Transmitter inverted data input
Module transmitter ground
vEdge 2000 Router