Cisco vEdge Series Hardware Installation Manual page 142

vEdge 1000 Router
Install the vEdge 1000 Router
2. Gradually remove the accessory box and the packing foam holding the rack-mount tray and the accessories
in place. See Figure 2.
3. Take out the rack-mount tray and each accessory.
4. Verify the components against the packing list included in the box (see packing list below).
Figure 4: Unpacking the Rack-Mount Kit
Packing List for the Rack-Mount Tray Kit
The cardboard carton in which the rack-mount tray and the accessory box are packed includes a packing list.
Check the parts you receive with your rack-mount kit against the items on the packing list. The packing list
specifies the part number, name, and quantity of each item in the carton.
If any part on the packing list is missing, contact your customer service representative or contact Viptela
customer support from within the U.S. or Canada by telephone at 800-525-5033 or by email to
support@viptela.com .
Table 2 lists the parts shipped in the rack-mount kit and their quantities. Figure 3 shows a graphical
representation of the screws and nuts included in the kit.
Hardware Installation Guide for vEdge Routers
136