Makita 4076D Technical Information page 4

R
epair
[1] DISASSEMBLY/ASSEMBLY
[1]-2. Motor Assembly
ASSEMBLING
(1) Assemble Fan cover and Rubber ring as illustrated in Fig. 10.
Fig. 10
Motor assembly
Triangle
mark
While aligning Triangle mark to the
protrusion of Base, assemble Fan cover
to Base.
(2) Connect Receptacles to the terminals of DC Motor. (Fig. 8, Fig. D-2 in Wiring diagram)
(3) Take the disassembling step in reverse. Refer to Figs. 7 to 3.
[1]-3. Battery
(1) Remove Rear cover as illustrated in Fig. 5.
(2) Remove Battery from Housing set. And then disconnect the connector of Controller's Lead wires from the connector of
Battery as illustrated in Fig. 6. Now Battery can be replaced.
protrusion
Rubber ring
Base
Fan 82
Fan cover
Fan cover
Fitting the groove of Rubber ring
to the protrusion of Base, assemble
Rubber ring to Base.
groove
protrusion
Base
Note: The wrong aligning and
fitting make it impossible
to match Housing set L
and R completely.
P 4/ 6