Sony SRX-T420 Installation Manual page 27

In case of LKRI-005
m
. For INPUT A slot, LKRI-005 is installed by default. However, LKRI-003 can be installed.
. When using a long cable, the image may not be displayed properly due to the signal attenuation.
. When the 10 bit single mode is selected, the DVI cable applicable to Dual-link is required.
1. Connect the commercially available DVI cable to the
terminal according to the input signal.
Input signal
During normal operation
DVI1.0 compliant
Signal level: Full Range
10 bit signal of its own specifi cation
During input (10 bit twin mode)
Signal level: Full Range
10 bit signal of its own specifi cation
During input (10 bit single mode)
Signal level: Full Range
Used during signal input of DTV standard
DVI1.0 compliant
Signal level: Limited Range
10 bit signal of its own specifi cation
During input (10 bit twin mode)
Signal level: Limited Range
10 bit signal of its own specifi cation
During input (10 bit single mode)
Signal level: Limited Range
Pin location
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
DVI-D terminal, AUX terminal
Pin No. Signal name
1 DATA2_
2 DATA2+
3 GND
4 DATA4_
5 DATA4+
6 DDC_SCL
7 DDC_SDA
8 NC
9 DATA1_
10 DATA1+
11 GND
12 DATA3_
SRX-T420
Used terminal
DVI-D terminal
DVI-D terminal
and AUX terminal
DVI-D terminal
DVI-D terminal
DVI-D terminal
and AUX terminal
DVI-D terminal
Pin No. Signal name
13 DATA3+
+5 V
14
15 DDC_GND
16 HOTPLUG_DET
17 DATA0_
18 DATA0+
19 GND
20 DATA5_
21 DATA5+
22 GND
23 CLK+
24 CLK_
LKRI-005
To DVI-D terminal
DVI-D cable
(optionally available)
To DVI output terminal
Personal computer
Fig. 1-7j
To AUX terminal
1-21