Sony SRX-T420 Installation Manual page 21

13. Place the anode side of the lamp bulb on the anode
holder.
14. Attach the anode harness to the anode terminal, then
tighten the bolt. (Tightening torque: 1.5 N.m).
n
After installing the anode harness separated lamp bulb,
if there is a clearance in portion A of the anode holder,
adjust it by bending the anode harness so that there is
no clearance between the anode holder and the lamp
bulb.
15. Tighten the hexagon socket set screw of the cathode
terminal.
(Tightening torque: 1.2 N.m)
n
Be sure that there is no clearance between the end face
of the cathode terminal and the surface C of the lamp
bulb.
16. Attach the panel (U4) block assembly (420) in the
reverse order of steps 3 to 5.
SRX-T420
In the case of anode harness integrated lamp bulb
Lamp bulb
Anode
holder
Anode
harness
In the case of anode harness separated lamp bulb
Lamp bulb
Anode
holder
Anode
harness
Anode holder
Knob
Anode harness
Anode terminal
End face
Lamp bulb Surface C
Fig. 1-6i
No clearance
Portion A
Adjust by bending
this portion.
Cathode terminal
Hexagon socket
set screw
Bolt
Cathode terminal
1-15