Receiving And Ending Video Calls - Cisco SX80 User Manual

Receiving and Ending Video Calls

Receiving Calls
Your Cisco SX80 with Touchpad 10 solution has been configured to automatically accept all
incoming connection requests. This means that both site to site connections initiated by
another site and multi-site connections will be automatically connected .
confirm if your particular equipment has been configured this way.)
You will hear a dial tone that indicates there is an incoming call and your microphone will
automatically mute so that the connecting site cannot overhear what you are discussing . Once
the connection is made, you will need to unmute your microphone so that the other site(s) can
hear you .
Ending Calls
At the completion of every call, press End to disconnect .
• Multi-site (MCU) sessions will be connected to the event automatically at the scheduled start time.
• If you are registered for the event and it is already in progress and you are NOT connected, you can
join by using the connection information shown on the Whiteboard .
• MCU calls will be automatically disconnected at the scheduled end time .
MBTelehealth - SX80 with Touchpad10 User Guide
Receiving and Ending Video Calls
(Note: Contact your FES to
Page 16 of 19