Makita DHP482 Technical Information page 7

Flat portion of
Brush holder
complete
The flat portion of Brush holder
complete must be vertical
against Housing L.
8. Put Torsion spring back into the space to hold Carbon brush.
8. Fit the concave portion of F/R change lever to the projection
of Switch.
2－10
Make sure that the side surface of Brush
holder complete is fitted in the inside of
Housing L's rib.
2－11
Notch of F/R change lever
Projection of Switch
Makita Corporation
Be sure that the rib of Housing L is
fitted in the groove of Change ring.
Brush holder complete
P 7/ 11