Makita DHP482 Technical Information page 11

The projection of Earth terminal (if used) must be faced to the opposite side of Yoke unit or Yoke unit side.
Projection
of Earth terminal
Earth terminal
Fig. 3
Brush holder complete
Do not put the sag of lead wire that is
connected to Earth terminal (if used)
on Shadowed area and Boss A.
Line filter
（if used）
Put Line filter (if used) to the left side of Rib F.
Put the sag of Lead wires of LED circuit
in this space.
Non-insulated terminals protected
by Polyolefin tube
(when repairing LED circuit)
Terminal
unit）
OK（opposite side of Yoke
Yoke unit
Projection of Earth terminal
Put lead wire that is connected to Earth
terminal (if used) in this lead holder.
Rib F
Shadowed area
Line filter
（if used）
OK （Yoke unit side）
Projection of Earth terminal
Heat sink
Boss A
Put Line filter (if used) in this space.
Makita Corporation
NOK sample
Yoke unit
Projection of Earth terminal
LED circuit
Put Heat sink as drawn.
Switch
Put Non-insulated terminals protected
by Polyolefin tube (when repairing
LED circuit) inside dotted line.
Fig. 4
P 11/ 11
Yoke unit