Functional Description; Installing Or Removing Battery Cartridge; Overload Protection - Makita XML03 Instruction Manual

FUNCTIONAL
DESCRIPTION
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
CAUTION:
Make sure that you lock the battery
cover before use. Otherwise, mud, dirt, or water may
cause damage to the product or the battery cartridge.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: The tool does not work with only one battery
cartridge.
To install the battery cartridge;
1. Pull up the locking lever, and then open the battery
cover.
► 1. Battery cover 2. Locking lever
2.
slot on the mower then slide the cartridge until it locks in
place with a little click.
► 1. Battery cartridge
3.
as far as it will go.
► 1. Lock key
1
4.
latched with the locking lever.
To remove the battery cartridge from the mower;
1.
the battery cover.
2.
sliding the button on the front of the cartridge.
3.
4.
2
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions:

Overload protection

When the battery is operated in a manner that causes
it to draw an abnormally high current, the tool automati-
cally stops and the main power lamp blinks in green. In
this situation, turn the tool off and stop the application
that caused the tool to become overloaded. Then turn
the tool on to restart.
8 ENGLISH
Align the tongue on the battery cartridge with the
Insert the lock key in the place shown in the figure
Close the battery cover and push it until it is
Pull up the battery cover locking lever and open
Pull out the battery cartridge from the mower while
Pull out the lock key.
Close the battery cover.
1
1