Cisco 7800 Series Firmware Migration Master Manual page 14

4. Upload
your
license
file you
received from Cisco onto the CUCM. For details on how to obtain the license file from Cisco, see the Appendix.
a) Download the license file to your computer.
b) Access https://CUCM-ip-address/cmplatform/, where CUCM-ip-address is the IP address of the Unified CM.
c) Navigate to Software Upgrades -> TFTP File Management -> Upload file.
d) Select the license file and upload the file.
e) Restart the TFTP Service on the Unified CM
Note: If you previously uploaded a license file for Enterprise to MPP conversion with MAC.lic (00CCFC123456.lic) name,
you may want to use a different name for the MPP to Enterprise conversion license file, for example MAC_M2E.lic
(00CCFC123456_M2E.lic).
5. Determine the IP Address of your MPP phone. Press Applications
6. Type the following into your web browser:
7. In your web browser, navigate to Voice -> Provisioning.
8. Scroll down to "Firmware Upgrade" and paste the following into the "Upgrade Rule".
Upgrade Rule:
http://CUCM-ip-address:6970/sipxxxx.TLexM2E-11-2-3C-12.loads
Note: This is the path to the MPP-2-Enterprise transitional load. The transitional load is restricted from registering to call control.
This transitional load is an intermediate step to validate that the device is authorized to move from an MPP load to an Enterprise
load through the use of a license file.
Example:
Note: You can monitor the status of the upgrade via Info -> Download Status -> Firmware Upgrade Status to validate if there
are any errors with the download. In a few moments the phone should reboot. You can also check Info -> Status -> Phone Status -
> Upgrade Status for additional information.
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Internal Information.
7832
8811/41/51/61
MPP to Enterprise
8832
8845/65
http://ip_address_of_phone/admin/advanced
sip7832.TLexM2E-11-2-3C-12.loads
sip88xx.TLexM2E-11-2-3C-12.loads
sip8832.TLexM2E-11-2-3C-12.loads
sip8845_65.TLexM2E-11-2-3C-12.loads
and select Settings -> Status -> Network Status -> IPv4.
where sipxxx is the filename from Step 3
Page 14 of 30